Message Board

I just found this Studer FTP site that has helped me out a couple times.


ftp://ftp.studer.ch/public/Products/

I am trying to get a pair of Trident L30 Comps that were flooded out. I have gotten both units back up and running and only need a couple of output transistors. Does anyone know where I could find RCA 40361 and 40362?[/code]

I have a Trident 24 console here and I am looking for a set of schematics or any type of tech notes. There is no Left output of the stereo bus and I need drawings to bench test. Any ideas?


Thanks,

V

Need to Find Neve 1272 Male Edge Connector for a rack. The male pin block is worn and needs replaced. Its a 22p male, single side. I know its Amphenol but no model and no luck with sourcing. Thanks

I believe we have a set of these monitors at the shop. I am pretty sure that they are both are missing woofers but the cabs are in excellent condition. I will have to check on the model numbers to be sure that they are the same as what your looking for. I will get back to you on that. If you want to...

the heads for the 16 track are probably a bit more rare these days too. im sure they are worth more than the 24s.

You could also just try pulling out a few modules and see if the voltage comes back (with the PSU OFF, disconnecting is not a bad idea either). It could be a bum module, burnt wiring, and a number of other things. What does the supply look like without a load on it? Did he open up the supply and loo...

I need a new capsule for an RE20. Anyone know where they can be found other than just from Telex?

Is there any voltage getting to the lamps? Could be a blown fuse. The lamps could have all gone out but i dont think that is very likely. Are they LEDs or incandescent?

I have seen several old Tridents and serviced them in the past. Which model is it? There are two things that come to my ind right off. In the 80B series, someone had modded the Mix Buss outputs with Harting Op-Amps... I believe that was the brand... none the less. They had there own PSU because they...

I would assume that is what it's for but i can't guarantee. I looked it up online and didn't find any documentation. You need to find a user and/or tech manual.

It doesn't really appear that anyone tried to remove it. I think time and weather just oxidized the wire and it eventually broke off. I found this amp in a repair shop and the owner abandoned it because of the cost of repair i guess. I don't have any documentation on what it was in repair for nor do...

I have worked on a few of these in the past. What is the condition of the units? Are the excessively dusty and dirty inside? Is there any rust or burn marks where the circuit may have gotten to hot? Are the pots sticky or scratchy when you turn them? A lot of troubleshooting is just using your eyes ...

If I remember correctly, two of the wires were going to both of the 6v6 tubes from one of the transformers. Most of the moister seems to mainly be on the outside of the transformers and chassis. I think it may have just been from sitting in the humidity for so long. Tube amps are some what new to me...

It was missing the 6V6, AX7, and GZ34 tubes. There is about four wires that have popped off. I haven't gotten the tubes yet so i haven't turned it back on. It hasn't aged well. The face plate looks good but there is quite a bit of rust through out the rest on the unit.