Cr1604 vlz problem

Recording Techniques, People Skills, Gear, Recording Spaces, Computers, and DIY

Moderators: drumsound, tomb

Post Reply
User avatar
TheGreatOne
gimme a little kick & snare
Posts: 79
Joined: Tue Jan 31, 2006 6:05 am
Location: The Deeeeeeeeeeeep South

Cr1604 vlz problem

Post by TheGreatOne » Fri Jun 19, 2009 2:42 pm

Hey all, I have a 1604, about 10 years old, that now has this problem: channels 6 thru 13 won't show up in the main buss. If I put a signal to any of them, the signal is audible in solo mode only.
I've opened the case to have a look and note that its all multi-pin connectors. Since this problem affects adjacent channels rather than random ones, is it possible that one of the connectors is either unplugged or bad?

Any help anyone could throw my way would be greatly appreciated!!

Thanks,
Kev
When in doubt, consult the manual
Top
User avatar
mixedupsteve
pushin' record
Posts: 274
Joined: Sat Nov 24, 2007 10:20 am
Location: Maryland

Post by mixedupsteve » Sat Jun 20, 2009 7:24 am

There's many ribbon type connectors that are known to work loose, get dirty etc. If you have it open I would remove and clean all the connectors you can with De-oxit .
Does your mixer have the add on mic pres?(7-16) It has a ribbon conn to.
Top
User avatar
TheGreatOne
gimme a little kick & snare
Posts: 79
Joined: Tue Jan 31, 2006 6:05 am
Location: The Deeeeeeeeeeeep South

Post by TheGreatOne » Tue Jun 23, 2009 8:46 am

Add on mic pres? It has 16 mic pres in the board if thats what you mean. And thanks for the reply!!

Kev
When in doubt, consult the manual
Top
Post Reply

Return to “Creative Recording”

Who is online

Users browsing this forum: No registered users and 79 guests