Replace cable on RCA 77DX?
Replace cable on RCA 77DX?
Hey all, anyone know the process of replacing cables on a 77? I bought two with busted cables, looking to fix up. I can't seem to figurenout hownto get the base apart.
-Chris
http://www.ctmsound.com
http://www.ctmsound.com
OK, got the base apart. Question. Am I going to fry the ribbon if I de-solder the cables from the chasis? This may be a dumb question, but I don't want to mess this mic up.
-Chris
http://www.ctmsound.com
http://www.ctmsound.com
- I'm Painting Again
- zen recordist
- Posts: 7086
- Joined: Wed May 07, 2003 2:15 am
- Location: New York, New York
- Contact:
^wiring diagram
you should be fine using a normal iron..if you're worried about it heating up something add a heat sink betwixt the solder point and sensitive bits..
http://www.radioshack.com/product/index ... Id=2103242
- I'm Painting Again
- zen recordist
- Posts: 7086
- Joined: Wed May 07, 2003 2:15 am
- Location: New York, New York
- Contact:
- I'm Painting Again
- zen recordist
- Posts: 7086
- Joined: Wed May 07, 2003 2:15 am
- Location: New York, New York
- Contact:
Who is online
Users browsing this forum: No registered users and 180 guests