Hi all
I have a weird problem where I have noise between my mixer and my interface. when I isolate either one, the noise goes away. It sounds similar to when a cable is plugged into an amp without the instrument connected to the other side - the noise can be turned up or down depending on mixer gain.
ensemble 1/4" 1+2 outputs --> patchbay --> mixer inserts = noise
ensemble 1/4" 1+2 outputs ----------------->mixer xlr input = noise
ensemble 1/4" stereo headphone outputs--->mixer xlr input = noise
ensemble --------------------> speakers = no noise
iPhone/computer --------------> mixer = no noise
My gear:
-apogee ensemble firewire interface
-Ramsa 8716 mixer
the pin connections on the back panel of the ramsa read:
Ramsa Input Connection
no1: ground
no2: cold
no3: hot
So I'm confused why the computer doesn't make a noise, but the interface does. Also, could certain self-wired cables 'correct' the older pinouts of the Ramsa to play nice with the ensemble?
Anyone have any suggestions?
thanks!
matt
noise between ensemble interface and Ramsa mixer
noise between ensemble interface and Ramsa mixer
Kordorama
"One nation under a grooooove"
"One nation under a grooooove"
Who is online
Users browsing this forum: No registered users and 21 guests