I have everything to do bias on my 5050, but the oscillator..
May I use some tone generator in software?.
How do I know about proper level?.
Tks.
Oscillator...
A software tone generator should be fine. Read the manual to find out what frequency and voltage the test tone should be. Use a volt meter to adjust the level coming out of the software. For example, if your machine needs to see a 1k sine wave at +4, your volt meter should read approximately 1.23vac.
- I'm Painting Again
- zen recordist
- Posts: 7086
- Joined: Wed May 07, 2003 2:15 am
- Location: New York, New York
- Contact:
Who is online
Users browsing this forum: No registered users and 47 guests