I just picked up an Eventide Mixing Link along with a Strymon BigSky reverb pedal to use on my vocals for live shows. I was planning on using a Radial JS3 mic splitter to split the initial mic signal.
Radial JS3 output 1 = (Dry signal) JS3 > FOH.
Radial JS3 output 2 = (Wet signal) JS3 > Evntide Mixing Link > Strymon BigSky > FOH.
I'm a bit confused as to how to configure the Mixing Link for use when only using it for a wet signal. I'm also wondering if it would be best to set the BigSky reverb to a 100% wet mix ratio.
I know Joel's an endorser of the Mixing Link, so I'm hoping he'll (amongst any others who might have some solid advice) jump in with some tips/info.
Thx!!
Eventide Mixing Link questions
- Waltz Mastering
- steve albini likes it
- Posts: 335
- Joined: Sun Jan 18, 2009 4:22 am
- Location: Third Stone From The Sun
- Contact:
For MXLNK wet only set up, you can put the toggle switch under the MIX knob to 'FX ONLY' then the MIX knob becomes FX level (wet level).
There's a couple ways to do this depending on the specific details of the set up. gl
There's a couple ways to do this depending on the specific details of the set up. gl
Last edited by Waltz Mastering on Sat Jul 23, 2016 9:27 pm, edited 1 time in total.
Thx for the info.Waltz Mastering wrote:For MXLNK wet only set up, you can put the toggle switch under the MIX knob to 'FX ONLY' then the MIX knob becomes FX level (wet level).
The are a couple ways to do this depending on the specific details of the set up. gl
My iTunes
Who is online
Users browsing this forum: No registered users and 43 guests