Message Board

Triac

Look between the reel table and the chassis.There are two set screws that hold the reel table assy to the reel motor shaft.Old one's have Phillips head screws, the newer one have Allen screws,loosen and adjust reel table height to taste.

we call them "boat anchors"

Reseat all the R/P cards.It could also be flaky head switching relays

No, that bracket has a thrust washer on it to stabilize the capstan motor shaft end play,and keep the capstan shaft from falling out..

And the drummer always gets the last choice when it comes to the groupies

May as well buy a good op/main manual from Tascam for the Ms-16.
Parts @ teac.com or 323-726-0303 ex.840 if you are in the U.S.

Digikey too

Broken or cracked solder joints, PCB cracked,damaged/intermittent traces or thermally sensitive components.As the unit warms up in any of the mentioned scenarios,the different matl.,(fiberglass,copper,solder, internal structure of the component,etc.), expand/contract at different rates.In other word...

Parts@ Teac.com or 323-726-0303 ex.840 if you are in the U.S. will sell you the real manual.The original manual was a combo operation/maintenace manual.

BOW-WOW

Hello all.need a schematic for a fostex spa 11 monitor.Fried it @ the last gig

The half hour it takes to build a phase switch is well worth it-one less digital process to muck up the mix,Besides, what's a half hour compared to the hours we spend on this forum.

Up for sale Tascam SX-1SE,the top of the line with all the options.Extra M/B,drive caddies,other stuff too. NEW- out of box,turned on but never used.
$2500/best offer.PM me

You need to verify that the "pro" has the service manual,playback alignment tape,and the necessary test equipment,(O-scope and VTVM). There are input levels,meter levels,playback levels,playback EQ,Bias and record level adjustments to be done.ANY one of these not done right will skew all the other a...