Message Board

Hello all, I have this 1/4" deck which has been in storage. I fired it up recently and realized that the NON take up side (left) has a slightly bent spindle..DAMN YOU STORAGE!!! I noticed this because the tape, when played, slows down to a stop, so, I'm figuring extra resistance from the misalignmen...

Hi Mike,
I have a m-ozonic keyboard midi controller / 4 in interface. FireWire only.
Also a Samson C-control if that is of interest.
Thanks for considering.

Hello all, I have noticed that I'm getting very low signal into this. I have been inputting -10 and +4 signals from a tone generator and the vu meters barely move. Also, the vu meters don't ramp up on power up and the bar meters go halfway and are kind of fluttery, for lack of a better word. I am ge...

,y set up has changed and have no use for it. Could I for instance use this as some kind of guitar in / amp switcher ?
I doubt this as there would be impedance issues, etc. and line level vs instrument level..
Hmmm. It's only worth about $40 and I don't have any friends to bestow it upon.
Ideas??

So I took delivery of the board tonite and got as far as seeing the serial number. It falls below the updated versions which allow you to change the transport controls from MMC to note on off... I use Ableton Live and this is an issue from what I have read. Damn,it's like 12000 units below the requi...

Hello everyone, After reading everything I could find about these, I pulled the trigger. This will be replacing a motu 8 pre, presous Fs, and an mbox 2 pro. Buying into technology that is this old is frightening, but I have a 45 day return if needed. I'm in the process of remodeling my control room,...

I have recently just added 8'x20"x12" deep traps in the corners. I used Roxul w/ landscaping screen over it. They currently are tight against the wall and don't have the mass I was hoping for, but they take up no more space then the emptiness that existed there before. And I have actually noticed a ...

Thanks. I think i got it sorted... Lol

ok Thanks JWL..
The corners it is then.

Appreciate the feedback.. I have 2" x 14" 703 type stuff in the corners. i know it isn't enough mass but until the next make over that is what it is.. If I jammed loose insulation behind the corners panels that would give me about 1' max depth in the corner @ 45 degrees.. Is insulation stuffed into ...

Ok, I've had a few and am sitting in my room which is 20 x 20 x 18 high. It's square. DOH! If I were suspend cloth wrapped balls of insulation (like maybe even a whole roll type thing), ( the cheap yellow construction type probably minus the paper backing?) covered in cloth to contain and make art o...

Thanks for your knowledge..

Howdy Would stones (round river stones) work as bass traps if they were mortared in place in the corners? I could leave an air gap behind it. I think they would be reflective but with the random sizes of the stone that may be alright. Would it be effective on the low end bass?? I'm thinking about 16...

I'm back to this same question years later..I just installed a Langevin DVC and am wanting to get the most out of this setup..
Thanks for any input

Langevin DVC.. My first real preamp. Picked it up from a friend for $1200.. I think we both did alright. I also grabbed a GIbson Ga-20 amp in great shape. 1954 i believe. $450 also from a friend.
So much for stocking up on bulk rice!!!