Replace cable on RCA 77DX?

ctmsound · Post by **ctmsound** » Sun Jun 05, 2011 10:20 pm

Hey all, anyone know the process of replacing cables on a 77? I bought two with busted cables, looking to fix up. I can't seem to figurenout hownto get the base apart.

ctmsound · Post by **ctmsound** » Sun Jun 05, 2011 10:57 pm

OK, got the base apart. Question. Am I going to fry the ribbon if I de-solder the cables from the chasis? This may be a dumb question, but I don't want to mess this mic up.

I'm Painting Again · Post by **I'm Painting Again** » Mon Jun 06, 2011 8:21 am

^wiring diagram

you should be fine using a normal iron..if you're worried about it heating up something add a heat sink betwixt the solder point and sensitive bits..

http://www.radioshack.com/product/index ... Id=2103242

ctmsound · Post by **ctmsound** » Mon Jun 06, 2011 9:47 am

Very cool, thanks

I'm Painting Again · Post by **I'm Painting Again** » Mon Jun 06, 2011 2:31 pm

notice you can wire it 3 ways for 30 150 or 250 Ohm impedance..

ctmsound · Post by **ctmsound** » Wed Jun 08, 2011 12:14 am

Wired it at 250, sounds great!

I'm Painting Again · Post by **I'm Painting Again** » Wed Jun 08, 2011 7:21 am

sweet. now can i borrow it?

LOL

Message Board

Replace cable on RCA 77DX?

Replace cable on RCA 77DX?

Who is online