Question about Tascam br 20

klute · Post by **klute** » Sat Jan 14, 2006 2:51 pm

I am borrowing a friend's Tascam br 20, 1/4" 2 track. I use it to mix down from my Tascam ms 16. I want to calibrate it but I can't find the pots to do it. I even took off the back panels. What gives? Anyone have an answer or a manual? Thanks

tilputt · Post by **tilputt** » Mon Jan 16, 2006 8:23 pm

as far as I can tell the manual doesn't say:

http://www.tascam.com/Products/BR-20/br20_manual.pdf

klute · Post by **klute** » Mon Jan 16, 2006 8:45 pm

Thanks a lot for the download. That is nice of you. But, I'll be damned; no mention of calibration!

mikelevitt · Post by **mikelevitt** » Mon Jan 16, 2006 8:54 pm

timothybluhm wrote:I am borrowing a friend's Tascam br 20, 1/4" 2 track. I use it to mix down from my Tascam ms 16. I want to calibrate it but I can't find the pots to do it. I even took off the back panels. What gives? Anyone have an answer or a manual? Thanks

I think you need to keep pulling panels until you find the pots. I used to own a 3340, and I recall the adjustments were under the bottom panel - but it's been a LONG time....

Also, check for a piece of foil backed paper - I had a revox A77, and on that one you had to punch through the paper to see the pots.

They've got to be in there somewhere!

Mike

analogcat · Post by **analogcat** » Tue Jan 17, 2006 4:58 am

On all my TEAC's and Tascam's it's been the bottom panel.

Message Board

Question about Tascam br 20

Question about Tascam br 20

Re: Question about Tascam br 20

Who is online