yanking the reverb out of a stereo receiver

Recording Techniques, People Skills, Gear, Recording Spaces, Computers, and DIY

Moderators: drumsound, tomb

Post Reply
User avatar
ryangobie
steve albini likes it
Posts: 306
Joined: Fri Aug 29, 2003 5:12 pm
Location: jersey

yanking the reverb out of a stereo receiver

Post by ryangobie » Fri Jun 30, 2006 2:18 pm

i suppose i'm in the same boat as the person with the peavey they're ripping apart, but unlike him, i don't have the accutronics site with all it's info. this is an old pioneer stereo receiver with the most messed up sounding reverb in it. i must have it. but before i go ripping into it, should i take any voltage readings for the circuit around it or just pull the reverb tank or try to take out the reverb circuity as a whole? any suggestions?
weeeee

User avatar
brianroth
tinnitus
Posts: 1164
Joined: Thu Dec 09, 2004 12:32 am
Location: Oklahoma City

Post by brianroth » Sat Jul 01, 2006 11:24 pm

See if you can find any service info/schematics for that model via a 'net search.

Bri
Brian Roth Technical Services
Oklahoma City, OK
http://www.brianroth.com/

User avatar
Roboburger
buyin' gear
Posts: 536
Joined: Wed May 07, 2003 7:44 am
Location: Williamstown, MA

Post by Roboburger » Tue Jul 04, 2006 12:10 am

why yank it out at all? if it's the kinda thing you're not gonna use all that often, leave it where it is! You''ll wow a client someday when you pull it out of a closet and run signal through it.
Audio Engineer Euphemism for going number two: "Rollin' off the Low End."

Post Reply

Who is online

Users browsing this forum: No registered users and 50 guests