RMG 1/2" 911 prblems?
-
- gettin' sounds
- Posts: 141
- Joined: Mon Jul 14, 2003 12:05 am
- Location: northampton, Massachusetts
- Contact:
RMG 1/2" 911 prblems?
is anyone having any problems with the new batches of RMG? I've been getting a lot of shedding and some level drops. I'ven ever had these problems with Ampex or Quantegy.
- Russian Recording
- re-cappin' neve
- Posts: 752
- Joined: Wed May 21, 2003 2:28 pm
- Location: Bloomington, IN
- Contact:
- Russian Recording
- re-cappin' neve
- Posts: 752
- Joined: Wed May 21, 2003 2:28 pm
- Location: Bloomington, IN
- Contact:
- JohnDavisNYC
- ghost haunting audio students
- Posts: 3035
- Joined: Fri Oct 03, 2003 2:43 pm
- Location: crooklyn, ny
- Contact:
- JohnDavisNYC
- ghost haunting audio students
- Posts: 3035
- Joined: Fri Oct 03, 2003 2:43 pm
- Location: crooklyn, ny
- Contact:
I had some 2" 911 shed on me about 6 weeks ago. Got through calibrating about 3 channels and it was all over. Less than ten minutes on the machine and it was trashed.
Although RMG was very cool and replaced it, I was told it failed due to the wear patterns on my machine comprimising the edges of the tape. This would really only involve the lifter as everything else is rollers.
I have not tried the new reel (SM900) they sent yet.
I am so hoping it was really a bad batch, as I really want to run RMG product and not have to hunt for used Quantegy.
mm
Although RMG was very cool and replaced it, I was told it failed due to the wear patterns on my machine comprimising the edges of the tape. This would really only involve the lifter as everything else is rollers.
I have not tried the new reel (SM900) they sent yet.
I am so hoping it was really a bad batch, as I really want to run RMG product and not have to hunt for used Quantegy.
mm
"Two things are infinite: the universe and human stupidity, and I'm not sure about the universe." - Albert Einstein
- @?,*???&?
- on a wing and a prayer
- Posts: 5804
- Joined: Wed May 07, 2003 4:36 pm
- Location: Just left on the FM dial
- Contact:
They are having slitting problems at the plant. This affects the width of the tape. I had the same issue with Batch #0911B006040-34120
Call RMGI. Give them your batch number and they'll send replacements promptly. The replacement reels were fine, but I will keep my eyes peeled for this problem in the future.
Call RMGI. Give them your batch number and they'll send replacements promptly. The replacement reels were fine, but I will keep my eyes peeled for this problem in the future.
Who is online
Users browsing this forum: No registered users and 140 guests