Does anyone have any patchbay label templates in possibly xls format?
I have some ADC 96 point bay that I have to label. Any help would be greatly appreciated.
Thanks.
Patchbay Label Templates
- jessejamietig
- gimme a little kick & snare
- Posts: 96
- Joined: Fri May 16, 2003 6:30 am
- Location: San Francisco
- Contact:
Neutrik has a patchbay labeling program with some templates. See if anything matches up.
Neutrik PatchLabel (zip file, on the right side menu)
Neutrik PatchLabel (zip file, on the right side menu)
-
- TapeOp Admin
- Posts: 1665
- Joined: Thu May 01, 2003 11:50 am
- Location: Portland, OR
- Contact:
I made my own with Excel. Different patchbays have different layouts, be forewarned.
Larry Crane, Editor/Founder Tape Op Magazine
please visit www.tapeop.com for contact information
(do not send private messages via this board!)
www.larry-crane.com
please visit www.tapeop.com for contact information
(do not send private messages via this board!)
www.larry-crane.com
- sonicmook56
- steve albini likes it
- Posts: 357
- Joined: Tue Mar 09, 2004 3:05 pm
- Location: Echo Park
- analogcabin
- buyin' gear
- Posts: 589
- Joined: Thu May 08, 2003 10:38 am
- Location: Afton, Virginia
- Contact:
- gullfo
- alignin' 24-trk
- Posts: 62
- Joined: Wed Feb 09, 2005 11:04 am
- Location: Old Tappan, NJ USA
- Contact:
and bear in mind the printer type will also make a difference how they are rendered compared to whatever ruler you use in the program so make a blank template that lines up and then use it to create the rest. Excel, Word, or OpenOffice should all work fine.
Glenn
www.runnel.com/
www.runnel.com/
Who is online
Users browsing this forum: No registered users and 66 guests