Logic 8 problemos

timbone · Post by **timbone** » Mon Mar 31, 2008 12:56 pm

So, I'm having overload and dropout problems with logic 8. All it takes is one instance of a plug-in and then the problems begin, at any buffer setting. This all started after I did an apple software update without really looking at what I was updating! I had no problems before that. I've noticed that others are having a similar experience. Is there a fix? Is it me or is it Apple?

I'm running it on a macbook pro with two gigs o' ram with a uln-2.

Any help is appreciated.
Cheers.
Tim

palinilap · Post by **palinilap** » Mon Mar 31, 2008 2:37 pm

Try installing the 10.5.2 combo update from Apple's site. If you've already installed 10.5.2 that's ok, just install the combo update over it.

timbone · Post by **timbone** » Mon Mar 31, 2008 11:51 pm

Thanks for the reply. Unfortunately, I'm still running 10.4.11. I guess it's time for 10.5

palinilap · Post by **palinilap** » Tue Apr 01, 2008 7:55 am

Ah, my bad. Then just run the 10.4.11 combo update instead:

http://www.apple.com/downloads/macosx/a ... intel.html

timbone · Post by **timbone** » Tue Apr 01, 2008 10:34 am

Thanks again palinilap. Unfortunately, even after the downlowd, I'm still having the same problem.

timbone · Post by **timbone** » Tue Apr 01, 2008 11:13 am

I think I figured it out. Like I said the problems began after that update prompt from apple. There was an update for airport that doesn't want to play nice with logic. When I turn the airport off logic runs fine. This is stupid.

Message Board

Logic 8 problemos

Logic 8 problemos

Who is online