Adapter for Altec outs?
Adapter for Altec outs?
The old school screw type thing. Googling "screw to 1/4 trs" didn't yield any usable results.
- the finger genius
- re-cappin' neve
- Posts: 746
- Joined: Wed Nov 15, 2006 1:32 pm
Basically you just want bare wire on one end and 1/4" trs on the other, right? I would just open up one end of a trs cable. You can order bare end custom made cables from Redco as well, but I don't see much point in it.
_________________vvv wrote:
That said, what I'm gettin' at is, perfectionism is for the truly defective.
You may quote me.
- Mudcloth
- steve albini likes it
- Posts: 332
- Joined: Sat Nov 01, 2003 6:30 pm
- Location: Elgin, Texas
- Contact:
What Altec is it? I would use the 600 ohm out if you're going into a recorder or d/a converter.
On a lot of Altec gear you'd be using terminals 1 and 4 for that, and strapping terminals 2 and 3 together. There's a cool little connector that came with old Altecs that I bet you'll never find if it doesn't have it. You'll have to make a bridge with those spade lugs or "crimp connectors", as I call them. Good luck!
On a lot of Altec gear you'd be using terminals 1 and 4 for that, and strapping terminals 2 and 3 together. There's a cool little connector that came with old Altecs that I bet you'll never find if it doesn't have it. You'll have to make a bridge with those spade lugs or "crimp connectors", as I call them. Good luck!
Matt Giles
Austin, Tx
http://www.mattguitargiles.com
http://www.myspace.com/mattguitargiles
http://www.thedrakesband.com/
How much is a stamp? I'll buy the goddamn stamp.
Austin, Tx
http://www.mattguitargiles.com
http://www.myspace.com/mattguitargiles
http://www.thedrakesband.com/
How much is a stamp? I'll buy the goddamn stamp.
Who is online
Users browsing this forum: No registered users and 268 guests