Hi everybody,
I recently purchased 2 carnhill VTB 2280 600:600 transformers to patch them into my ITB setup. I checked out the website to wire these to balanced jacks but can't really figure it out. Anyone could give me some help how to wire these?
On the 4th page of this pdf you can find all the info:
http://www.audiomaintenance.com/downloa ... _guide.pdf
Thanks a lot!
carnhill transformer wiring
- RodC
- dead but not forgotten
- Posts: 2039
- Joined: Thu Dec 30, 2004 8:53 pm
- Location: Right outside the door
- Contact:
Assuming you are using balanced plugs
Input
Tie 2 and 4 together (Series to get 600 ohms)
Pin 1 to tip
Pin 3 to ring
Connect Sleeve from one plug to the other using shield, if you are using a shieled box, connect shield to box
Output
Tie 6 and 7 together (Series to get 600 ohms)
Pin 5 to tip
Pin 8 to ring
Connect sleeve from one plug to the other using shield, if you are using a shieled box, connect shield to box
If it's noisy after you patch it in, you may want to disconnect the shield on each cable from your new enclosure
Input
Tie 2 and 4 together (Series to get 600 ohms)
Pin 1 to tip
Pin 3 to ring
Connect Sleeve from one plug to the other using shield, if you are using a shieled box, connect shield to box
Output
Tie 6 and 7 together (Series to get 600 ohms)
Pin 5 to tip
Pin 8 to ring
Connect sleeve from one plug to the other using shield, if you are using a shieled box, connect shield to box
If it's noisy after you patch it in, you may want to disconnect the shield on each cable from your new enclosure
'Well, I've been to one world fair, a picnic, and a rodeo, and that's the stupidest thing I ever heard come over a set of earphones'
http://www.beyondsanityproductions.com
http://www.myspace.com/beyondsanity
http://www.beyondsanityproductions.com
http://www.myspace.com/beyondsanity
Who is online
Users browsing this forum: No registered users and 48 guests