How to get balanced signals into unbalanced gear?
- shedshrine
- deaf.
- Posts: 1868
- Joined: Tue Jun 01, 2004 5:47 pm
- Location: sf bay area
How to get balanced signals into unbalanced gear?
Trying to get balanced gear to play nice with an electrix repeater. Is there some converter box or adaptor for this? I've got a balanced patchbay, and I dont' want to have to route through a mixer if possible. Is it worth trying to get someone to convert the repeater to balanced I/O? Thanks.
- I'm Painting Again
- zen recordist
- Posts: 7086
- Joined: Wed May 07, 2003 2:15 am
- Location: New York, New York
- Contact:
Re: How to get balanced signals into unbalanced gear?
this is a good way to mate those puppys :
http://www.ebtechaudio.com/lls-2des.html
there are three ways to wire if your not going to use that box depending on the output stage(s) of your balanced gear:
http://www.vandenhul.com/artpap/wiring4.htm
you will lose 6db of gain with out the matcher box which can be ok or can cause minor problems like increased noise floor.
hope this helps.
http://www.ebtechaudio.com/lls-2des.html
there are three ways to wire if your not going to use that box depending on the output stage(s) of your balanced gear:
http://www.vandenhul.com/artpap/wiring4.htm
you will lose 6db of gain with out the matcher box which can be ok or can cause minor problems like increased noise floor.
hope this helps.
Re: How to get balanced signals into unbalanced gear?
i usually just plug it right in. What's wrong with this?
- I'm Painting Again
- zen recordist
- Posts: 7086
- Joined: Wed May 07, 2003 2:15 am
- Location: New York, New York
- Contact:
Re: How to get balanced signals into unbalanced gear?
the 6db's of make up gain you need to apply..not a huge deal but every little bit helps..also i hear that a cross-coupled balanced output wired with a floating ground can cause a lot of bad things to happen..and inverting op-amps dont take kindly to grounding the unused lead in a cable..this is just what im told by some geeks..maybe some one here more technically inclined can give you the reasons why..because im not really sure..its all greek to me..J. wrote:i usually just plug it right in. What's wrong with this?
- Scodiddly
- speech impediment
- Posts: 4012
- Joined: Wed Dec 10, 2003 6:38 am
- Location: Mundelein, IL, USA
- Contact:
Re: How to get balanced signals into unbalanced gear?
Poke around http://www.markertek.com, there are a bunch of little black boxes that do balanced/unbalanced and +4/-10 conversion.
Who is online
Users browsing this forum: No registered users and 12 guests