Does anyone have a recommendation for which tubing to use for ground wires on ADC punchback bays? Would the 3/64 '' stuff that Redco has work???
Thanks.
preslav
shrink tubing for grounds/drains
-
- gimme a little kick & snare
- Posts: 94
- Joined: Wed May 07, 2003 11:43 am
- Location: near boston
Re: shrink tubing for grounds/drains
rather than use shrink tubing, there's this stuff out there that's made out of teflon that I use. You buy the proper gauge you need, and just slip it over the bare wire. Thing is, though, you have to trim it back properly so there is bare wire going into that ADC punchblock hole. The teflon stuff doesn't get pierced enough like regular wire insulation.
Some of the stuff is here.
jerry
Some of the stuff is here.
jerry
Re: shrink tubing for grounds/drains
I recently did an ADC patchbay and I didn't trim back the teflon...........and sure enough on some patches I'm getting some hum. I bet that is what is happening. I am not looking forward to re-doing the whole thing over, but at least I'll know where to start looking for the problem!jerrymac wrote:rather than use shrink tubing, there's this stuff out there that's made out of teflon that I use. You buy the proper gauge you need, and just slip it over the bare wire. Thing is, though, you have to trim it back properly so there is bare wire going into that ADC punchblock hole. The teflon stuff doesn't get pierced enough like regular wire insulation.
Some of the stuff is here.
jerry
Who is online
Users browsing this forum: No registered users and 130 guests