SOLD - 2 JoeMeek VC3Q's - $130 each

*Gear*ed towards individuals who are buying/selling - NOT a place for businesses to post their goods for sale.

Moderators: TapeOpLarry, tomb

Post Reply
underthebigtree
pushin' record
Posts: 219
Joined: Tue Jun 03, 2003 9:44 am
Location: San Mateo, CA
Contact:

SOLD - 2 JoeMeek VC3Q's - $130 each

Post by underthebigtree » Wed Dec 30, 2009 2:00 pm

Both units have been sold.

Two JoeMeek VC3Q Channel strips in good condition. Smoke free studio use only, everything works perfectly. Some small scuffs and scratches on top plate, but face plates are perfect.

These units are not made anymore. Go search TapeOp about these units - they are very highly regarded. Includes upgraded power supplies. Each unit is $130.

Cash pickup in San Mateo, CA (San Francisco Bay Area), or buyers pay shipping/paypal.

Thanks for looking!

VC3Q Specification:

Mic: 1.2kohm; Line: 20kohm
Pre-amp overall gain: 0dB to 60dB
Common mode rejection: 70dB
Equivalent input noise: -128.5dBu (unweighted)
Distortion: 0.001% (below Compressor threshold)
Frequency response: 10Hz to 70kHz (-3dB)
Maximum input before clipping: Mic: +19.5dBu; Line: +44.5dBu
Headroom before clipping: +19.5dBu
Compressor threshold: +∞dBu to -20dBu (variable)
Compressor ratio: 5:1 (typical)
Compressor attack time: 1 msec to 100 msec (adaptive)
Compressor release time: 0.1 sec to 3 sec (adaptive)
EQ Boost and Cut: +/-15dB (zero phase-shift bell response)
LF Frequency: 80Hz (fixed)
MID Frequency: 300Hz to 5kHz variable
HF Frequency: 12kHz (fixed)
EQ ?Q?: 0.9 (1.6 octaves)
Output Gain: -∞dBu to +16dBu (variable)
Nominal output levels: +4dBu/-10dBv (selectable)
Output impedance: 75ohm
Output Level switch: 12dB attenuation
Noise Floor: -85dBu (typical, with ~40dB mic gain)
VU Meter: 8 segment bargraph
Power supply: 12V ac mains adaptor
Power consumption: 12W
Mechanical: 220W x 44H x 180D (overall)
Last edited by underthebigtree on Sun Jan 03, 2010 6:18 pm, edited 2 times in total.

theslumlord
takin' a dinner break
Posts: 188
Joined: Mon May 26, 2003 12:09 pm
Location: Fullerton, CA
Contact:

Post by theslumlord » Wed Dec 30, 2009 8:23 pm

Sent PM

tonic889
alignin' 24-trk
Posts: 69
Joined: Tue Apr 11, 2006 8:08 pm
Location: Philly

Post by tonic889 » Wed Dec 30, 2009 9:42 pm

PM'ed

underthebigtree
pushin' record
Posts: 219
Joined: Tue Jun 03, 2003 9:44 am
Location: San Mateo, CA
Contact:

Post by underthebigtree » Thu Dec 31, 2009 6:01 pm

One unit sold!

underthebigtree
pushin' record
Posts: 219
Joined: Tue Jun 03, 2003 9:44 am
Location: San Mateo, CA
Contact:

Post by underthebigtree » Sat Jan 02, 2010 1:19 pm

bump - one unit left

Post Reply

Who is online

Users browsing this forum: No registered users and 3 guests