anyone ever opened a mixwizard?
- aurelialuz
- dead but not forgotten
- Posts: 2012
- Joined: Mon May 05, 2003 10:46 am
- Location: portland, or.
anyone ever opened a mixwizard?
i have to replace a fader and can't get the top off. i removed the screws on the rack ears, the two at the seam on the top, the screws on the sides holding the main board and the connections board together, and even the two around the bend underneath the main board and still there is something holding it down in the back. ??????
"While every effort has been made to ensure optimum sound quality, priority has been given to historic content and importance."
- rhythm ranch
- mixes from purgatory
- Posts: 2793
- Joined: Wed May 07, 2003 8:45 pm
- Location: Corrales, NM
From the manual (found here: http://www.allen-heath.com/uk/products/ ... Wizard3162)
Remove the base - Start by removing the side
trims if fitted using a Pozi crosshead screwdriver.
Release the two M4 Pozi head pod securing screws
and rotate the connector pod to gain access to the
three M3 rear base fixing screws. Use a Torx
starhead screwdriver to remove these. Rotate the
pod again to remove the four M3 underside base
screws using the Torx driver. Carefully lift off the
base.
Remove the base - Start by removing the side
trims if fitted using a Pozi crosshead screwdriver.
Release the two M4 Pozi head pod securing screws
and rotate the connector pod to gain access to the
three M3 rear base fixing screws. Use a Torx
starhead screwdriver to remove these. Rotate the
pod again to remove the four M3 underside base
screws using the Torx driver. Carefully lift off the
base.
- aurelialuz
- dead but not forgotten
- Posts: 2012
- Joined: Mon May 05, 2003 10:46 am
- Location: portland, or.
Who is online
Users browsing this forum: No registered users and 78 guests